You are using an outdated version of Internet Explorer. Please upgrade your browser to improve your experience.

Fin Designs

Roll Tooling Design - Fin Designs

The main purpose of the fin passes is to condition the strip edges to prepare them for welding.  The process must reduce the strip girth against the fin blade to accomplish this, and properly set the body of the strip.  The fin passes generate a great deal of drive if used properly.

Fin DesignsA standard fin blade works the entire strip edge and prepares it for welding.  A straight fin or one with altered angles is used to work the inside edges of the strip to reduce the I.D. bead.  Special attention must be used in setup to avoid having a cold I.D. weld and possible cracks.  A round fin pass design is most recommended unless the mill does not have side passes or there is a reason to use another style.

Low-bead fin blades are made when the customer wants to control the I.D. weld flash of the tube.  The angle is altered by approximately 5 degrees in just the last pass.  However, if the angle on the last pass is only 1 or 2 degrees, it would be beneficial to just remove the angle completely, and make it flat.

A flat oval design is most often used in the last pass and only in certain cases.  It is successful with Tig and Laser welding and with two-roll weld boxes of any weld type.

Fin DesignsA peaked fin pass design is used when there are no side roll passes between them, as occurs on large pipe mills.  In years past, the old design, low-frequency welders liked a peak tube to insure good electrode contact, but that is not really needed.  When Tig welding, the last fin pass is commonly finless, allowing the strip edges to be as closed as possible before the welder.

REQUEST FORM

Have a technical question? Need a sales quote? Get answers 24/7.

TESTIMONIALS